Package Content; Safety Instructions; Frequently Asked Questions - i-tec MySafe USB-A 3.0 Mode D'emploi

NEW HDD FORMATTING
1. Click the right mouse button on "My Computer".
2. Select "Manage"
3. Click on "Disk Management"
4. Select HDD described as "Unallocated" with a specified capacity of the
inserted disk (usually, a number with a few digit values lower is being
displayed).
5. Click the right mouse button on the disk area and select "New Simple
Bunch", click on "Next".
6. Leave the bunch size on the maximum and click on "Next"
7. Select "Allocate a Letter to the Unit" and click on "Next".
8. Select "Format the Bunch with the Following Setting" (leave the initial
setting). Click on "Next" and "Finish".
9. HDD formatting will be performed. The formatting time depends on the
HDD size. Afterwards the HDD is visible in the system.

PACKAGE CONTENT

• Extern case for 2,5" HDD
• USB 3.0 cable – length 60 cm
• Screw-driver
• Screws
• Rubber legs
• User manual

SAFETY INSTRUCTIONS

• Do not expose to extreme temperatures and air humidity.
• Use the device on flat surfaces – you will prevent it from slipping and
falling to the ground.
• Save the user manual for a possible use later.
In cooperation with the service department:
• Check functionality after falling to water or to the ground.
• Check functionality when the cover is broken.
• Send the device back if it does not work in accordance with the user
manual.

FREQUENTLY ASKED QUESTIONS

Available on our website www.i-tec.cz/en on the "FAQ" tab of this product.
Quick Start
ENGLISH | 5