Maintenance; Troubleshooting - Echo CPLB-58V Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE

WARNING
To avoid serious personal injury, always remove the
battery pack from the product when cleaning or
performing any maintenance.
WARNING
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause
product damage.
NOTICE
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance.
General Maintenance
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.

TROUBLESHOOTING

Problem
Motor fails to start when switch
trigger is depressed
Blower will not stop
Motor stops while switch trigger
is depressed
Possible Cause
Battery is not secure.
Battery is not charged.
Cruise control is on.
Motor is overloaded.
English
WARNING
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal
injury.
Cleaning the blower
 Stop the motor and remove the battery pack.
 Clean dirt and debris from the blower using a damp cloth
with a mild detergent.
NOTICE
Do not use any strong detergents on the plastic housing
or the handle. They can be damaged by certain aromatic
oils such as pine and lemon, and by solvents such as
kerosene.
Storage
 Remove the battery pack from the blower before storing.
 Clean all foreign material from the blower.
 Store indoors in a secure place that is inaccessible to
children. Keep away from corrosive agents such as garden
chemicals and de-icing salts.
 Do not hang unit so that the switch trigger is depressed.
To secure the battery pack, make sure the battery is
fully seated and the battery latch button on the tool is
snapped into place.
Charge the battery pack according to the instructions
included with your charger.
Turn off cruise control.
Release switch trigger, wait several seconds, then
depress trigger again. Motor should restart. If it doesn't,
remove battery pack, reinstall battery pack, and then
try again.
Solution
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cplb-58vvn

Table des Matières