Protection Circuit - Maxgear MAX 5073 Mode D'emploi

MAX 5073
Super Bass System
CONNECTING HIGH LEVEL INPUTS
NOTE: DO NOT CONNECT THESE HIGH LEVEL INPUT WIRES IF YOU ARE USING THE LOW LEVEL
INPUT RCA JACKS.
GRAY :Connect to Right(+)Speaker output of Car Stereo
GRAY/BLK :Connect to Right(-)Speaker output of Car Stereo
WHITE :Connect to Left(+)Speaker output of Car Stereo
WHITE/BLK :Connect to Left(-)Speaker output of Car Stereo
BLACK :Connect to Car Stereo Ground Wire
CONNECTING LOW LEVEL INPUTS
NOTE: DO NOT USE THESE RCA JACKS IN CONJUNCTION WITH HIGH LEVEL INPUT WIRES.
1. Always use high quality RCA type shielded cables
2. Always use the shortest length possible. If the cable is too long, make an "S" shape loop (not a
coiled loop) in the center of the cable to take up any excess.
3. Never cut the shielded cable and re-splice it.
4. Never route any Amplifier input cables near or parallel to speaker outputs, high energy ignition
wires, or near computer controlled ignition circuit units (Computer units may be found behind or
under the dash panel in late model cars).
POWER INDICATOR LED
This GREEN LED will illuminate whenever the Amplifier is turned "ON". If it fails to illuminate, check
the power connections to the Amplifier and fuses.

PROTECTION CIRCUIT

Should the amplifier become shorted, overloaded or overheated, the protect circuit will "SHUT-DOWN"
the Amplifier, and will remain inoperable until the condition that has caused the problem is corrected.
To reset, simply turn your radio "OFF" momentarily, and then turn "ON" again.
CAUTION: THIS AMPLIFIER IS DESIGNED TO OPERATE WITH A MINIMUM LOAD IMPEDANCE OF 2
OHMS IN STEREO, 4 OHMS IN MONO (BRIDGED), OR 8 OHM IN MULTI-MODE (TRI-MODE) CONSTI-
TUTE TO POTENTIAL DAMAGE TO THE MOSFET POWER SUPPLY.
L CH(+) WHITE
R CH(+) GRAY
CHASSIS GROUND BLACK
R CH(-) GRAY/BLACK
L CH(-) WITHE/BLACK