Maxgear MAX 5073 Mode D'emploi page 4

MAX 5073
Super Bass System
FEATURES&CONTROL
(1)RCA Line Input Jacks
To be connected to a line driver, crossover or head unit via RCA Cables.
(2)RCA Line Output Jacks
For connecting additional amplifiers for additional speakers.
(3)24dB Subsonic Filter Control
Permits a 24dB per octave high pass filter between 20-50Hz
(4)24dB Low Pass Variable Control
Adjustable low pass crossover frequency from 50Hz-250Hz
(5)24dB High Pass Variable Control
Adjustable high pass crossover frequency from 50Hz-250Hz
(6)0-18dB Bass Boost Control
The Bass Boost Control is used for a 0-18dB gain at 45Hz for extra bass punch.
(7)Input Gain Level Control
For adjusting the output of the amplifier to the input of the source unit. Adjustment range is from
0.2V to 8.0V.
(8)Power LED
The Blue color LED indicates that the power is on.
(9)Protection LED
The Red color LED indicates fault condition of amplifier.
When a fault condition occurs such as an overload, excessive heat or short circuit of speaker
terminals, the protection circuit is engaged to protect both the subwoofers and amplifier.
(10)Power Connection
Connect +12V DC power wire from battery source to amplifier.
(11)Ground Connection
Connects the Ground wire of amplifier to the chassis ground.
(12)Remote Connection
Connects the remote wire allowing the amplifier to be turned on/off by the head unit.
(13)Speaker Terminal
It allows the connection of a speaker to the amplifier.
(14)Fuse
Power protection for the amplifier.
HIGH/LOW PASS VARIABLE CROSSOVERS (50HZ-250HZ)
a) For use as a dedicated subwoofer channel(front or rear),select Lo pass switch. This activates the
low pass filter circuitry.
b) For us as a mid to hi range channel(front or rear),select Hi pass switch. This activates the hi pass
filter circuitry.
c) For normal full-range amplifier use, set to "FULL".