Subaru H001SFJ500 Instructions D'installation page 7

HOOD SAFETY SWITCH MOUNTING
8
1. In the engine compartment, locate the 2-pin pre-fit hood safety switch
connector secured to the ABS unit wire harness with breakaway tape
behind the air filter box on the passenger's side of the vehicle
(FIGURE AA).
2. Mount the hood safety switch bracket to the passenger side inner
fender support using the supplied 10mm bolt and pre-arranged weld
nut in the inner fender support. Torque the mounting bolt to 10.8 Nm
+/- 2 Nm (1.10 Kgf-m +/- 0.2 Kgf-m, 8 ft-lbs +/- 1.5 ft-lbs). The bottom
of the hood safety switch bracket will fit securely against the top of the
plastic fender wire harness grommet. (FIGURE BB)
3. Plug the supplied remote start harness 6" hood safety switch wiring
harness to the vehicle's 2-pin pre-fit connector. (FIGURE CC)
4. Securely mount (snap-in) the supplied hood safety switch into the
bracket and plug the vehicle's pre-fit 2-pin female hood switch connector
to the base of the hood safety switch. (FIGURE CC)
UNDER HOOD WARNING LABEL MOUNTING
9
1. Using alcohol clean the top of the air intake plenum.
2. Remove the adhesive backing of the underhood warning
label and secure to the top of the air intake plenum.
(FIGURE DD)
PART NUMBER ISSUE
H001SFJ500
DATE
00
20 Apr 2013
SUBARU OF AMERICA
WARNING: / AVERTISSEMENT
This vehicle is equipped with a remote controlled engine starter.
To reduce the risk of serious Injury or death, switch engine starter
system into service mode and disconnect the vehicle battery
before performing any service on the vehicle.
Ce véhicule est doté d'un démarreur à distance. Pour réduire les
risques de blessures graves ou mortelles, mettre le démarreur à
distance en mode service et débrancher la batterie du véhicule
avant d'effectuer des travaux d'entretien sur celui-ci.
FIGURE DD
7 OF 10