How To Attach The Light; Finishing Up; Factory Presets - Good Earth Lighting SE1294-WHG-02LF7-G Mode D'emploi

1
The fixture can be mounted on masonry and wood surfaces.
(see below).
Drill a 3/16 in. hole and place the masonry anchors in the pilot
holes and hammer them into place until flushed with surface.
Drive long screws into masonry anchor until snug.
1a
2
Line up the holes in the mounting bracket with the prepared mounting holes. Drive the screws in until the
mounting plate is secure.
Attach the security light to the mounting plate by positioning the security light above
the mounting plate. Slide the outer tabs on the security light into the grooves of the
mounting base until snug.
Set to
Range: 40 feet
Time: 20 seconds
(Duration)
If these settings are acceptable for your needs, you don't need to do anything more with the SetToGo
settings except doing the actual installation of the fixture.
The light turns on when the motion sensor detects movement. The sensor detects motion up to 40 ft. The 180-degree coverage of the
motion sensor is measured side-to-side. The sensor is more e ective side-to-side, rather than motion coming from the front (in and
out). The fixed timer is 20 seconds – The light will stay on for 20 seconds after motion detection (only during night hours).
ATTENTION!

How to Attach the Light

3/16 in.
4,8 mm
Masonry bit

Finishing Up

Adjusting the Light Heads
The individual light heads can be
adjusted up/down and left/right to
aim the light heads in the direction
desired.

Factory Presets

SetToGo: The security light is PRESET at the factory with the
following settings:
Detection distance
Time the light stays on after detecting motion
To change the factory SetToGo default settings, follow the
instructions on the next page.
Mounting
Plate
If mounting onto wood surface, drill 1/16 in. hole and
use the wood screws provided to secure the mounting
plate.
1/16 in.
1b
1,6 mm
Outer
Tabs
Light
Activation:
20 Seconds
5