Horizon Global 76595 Instructions D'installation page 4

1. Loosen wheel well trim and liner – Using a Phillips screwdriver or 8 mm socket remove (4) screws at the bottom of wheel well liner per side. Gently loosen the wheel
well trim on the wheel well liner up to the edge of fascia. Using a T20 torxbit remove (1) screw inside the wheel well liner per side. Using a 10 mm socket remove (1) bolt
behind wheel well trim per side.
2. Remove taillight panel and taillight – Open tail gate. Using a plastic trim tool remove (1) taillight panel per side. Using a T27 torxbit remove (1) screw on each taillight.
Gently remove the taillight and carefully remove the electric harness while removing the taillight.
©2022 Horizon Global™ Corp - Printed in Mexico Sheet 4 of 27 76595NP 05/19/22 Rev. A