Horizon Global 76905 Instructions D'installation page 5

3. Us e 17 mm s ocket to remove (2) bolts from tie down bracket on passenger side, s ee
Fi gure 2. Return ti e down bracket to vehicle owner.
5. Ra ise the hitch i nto position over existing weldnuts a nd i nstall M12 bolt ④ a nd
coni cal washer ⑤ (teeth side against hitch) i nto weldnuts.
Tighten all fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
©2019 Horizon Global Americas Inc. - Printed in Mexico
4. Remove plastic caps from 2 rea rmost existing weldnuts on the driver side, (a couple
l i ght twists with a standard s crewdriver makes this easier) remove the rearmost rubber
pl ug from the hole between the two weldnuts that were exposed earlier on the driver
s i de.
Sheet 5 of 15 76905NP 06-18-19 Rev. B