Blumfeldt Shinestone Mode D'emploi page 14

EN
14
First use
Turn the ON/OFF switch to position "ON" (for certain models - remove the
paper strip from the battery). The light is controlled automatically by a light
sensor. At sundown, the solar lamp turns on using the energy stored in the
battery. When you press the switch or insert back the paper strip, the solar
lamp turns off in order to save energy
If the solar lamp does not light automatically at sundown, check the following:
1. Make sure that the power switch is set to position "ON".
2. Check the battery to ensure that the battery terminals have a good
contact.
Battery replacement
• Batteries shall be disposed of in a safe way. Only dispose of batteries in
specific collection containers (contact your retailer for more information)
in order to protect the environment.
• Non-rechargeable batteries are not to be recharged.
• The supply terminals are not to be short-circuited.
• The battery must be removed from the luminaire before it is scrapped.
• Only use batteries of the following type:
1 battery of type 18650 / 3.7 V /1200 mAh