Product Installation And Usage; Installation Method - Klarstein WATERFALL Mode D'emploi

EN
22

PRODUCT INSTALLATION AND USAGE

Installation method

The product can be used directly after removing the package (without installation)
Usage of various function buttons
The buttons are touch buttons. You can tap the buttons on the operation panel to
trigger the corresponding functions.
1. When the power is turned on for the first time, the buzzer beeps twice and
enters standby mode; except the ON/OFF button, other buttons are invalid.
ON/OFF button:
2. in power-on state, press this button to turn on/off the
device.
After turning on, the system is in standby mode without any output.
When the device is turned on, the wind speed is at level 2 by default. After
turning off the device, its current state will be saved. But the timer setting
will not be saved. Same in case of sleep wind mode, it will switched to normal
mode for next time.
In power-on state, if there is no button or (remote control) operation for next
one minute, the brightness of all LEDs will be reduced by half. Press the ON/
OFF button again, the brightness will resume and you can perform further
actions.
Speed button:
3. in power on state, rotate this button clockwise to increase
the wind speed from level 1 to level 3; rotate this button counterclockwise
to reduce the wind speed from level 3 to level 1. LED indicator shows the
appropriate speed state.
4. Mode button: the device first enters normal wind mode; press this button to
enter the natural wind mode, press it again to enter sleep wind mode, and
press it again to enter normal wind mode. In natural wind and sleep wind
mode. LED turns on according to setting. In normal wind mode, no LED is lit.
Press the Mode button to switch the wind modes, which run as follows:
Normal wind
: high speed, medium speed, low speed
Natural wind: The main motor of the fan performs irregular operation according
to pre-programmed computer program. Combined with the wind speed button,
the natural wind can be set to high, medium and low level to simulate the effect of
nature wind, and make the wind more soft and comfortable. The wind speed LED
displays the corresponding speed, and the natural wind mode indicator turns on.