inventiv 202067 Mode D'emploi page 29

Make the setting as follows:
1 - 6 for driving small screws
7 - 12 for driving screws into soft material
13 - 18 for driving screws into soft and hard material
for heavy drilling
8. USING THE SIGHT LIGHT
To turn on the light, press the on/off switch and make sure
the forward/reverse rotation control is on right/left position.
When you release the on/off switch, the light will be off.
LED lighting increases visibility-great for dark or enclosed
area.
LED is also a battery capacity indicator. It will flash when
power gets low.
9. Battery Capacity Indication
Your tool is equipped with Battery Capacity Indication
(11). Press the On/Off Switch halfway or fully, the Battery
Capacity Indication will light up to show the amount of
charge left in the battery.
Fuel Gauge
3 lights
2 lights
1 light
1 flashing light
10. BELT HOOK (See Fig. J1, J2)
Screw the Belt Hook (7) on the tool with the screw
provided in the plastic bag. The Belt Hook can be hooked
on your belt or pocket, etc.
11. DRILLING
When drilling into a hard smooth surface, use a center
punch to mark the desired hole location. This will prevent
the drill bit from slipping off center as the hole is started.
Hold the tool firmly and place the tip of the bit at the point
to be drilled.
Depress the switch trigger to start the tool.
Move the drill bit into the workpiece, applying only enough
pressure to keep the bit cutting. Do not force or apply side
pressure to elongate a hole.
If you want to activate the drill function (For drilling metal
wood or plastic), turn the torque adjustment ring on the
drill position.
202067 CORDLESS DRILL 14.4V
Capacity
> 2/3
> 1/3
< 1/3
Recharge battery
29
SAFETY AND OPERATING MANUAL