inventiv 202067 Mode D'emploi page 28

202067 CORDLESS DRILL 14.4V
marked "
screws or release a jammed drill bit.
WARNING: Never change the direction of rotation
when the chuck is rotating, wait until it has stopped!
4. TWO-SPEED GEAR CONTROL (See Fig. F)
The drill has a two-speed gear control designed for drilling
or driving at LO (mark is 1) or HI (mark is 2) speeds. A
slide switch is located on top of the drill to select either LO
or HI speed. When using the drill in the LO speed range,
the speed will decrease and the drill will have greater
power and torque. When using the drill in the HI speed
range, the speed will increase and the drill will have less
power and torque.
Gear I
Low speed range: for screwdriving or working with large
drilling diameter
Gear II
High speed range: for working with small drilling diameter
WARNING:
To prevent gear damage, always allow the chuck
to come to a complete stop before changing the
direction of rotation or the two-speed gear control.
5. AUTOMATIC SPINDLE LOCK (See Fig. G)
The automatic spindle lock allows you to use it as a
regular screwdriver. You can give an extra twist to firmly
tighten a screw, loosen a very tight screw or continue
working when the battery energy has expired. For manual
screwdriver purposes, the chuck is automatically locked
when the tool is off.
6. CHUCK ADJUSTMENT (See Fig. H)
To open the chuck jaws rotate the front section of the
chuck. Insert the drill bit between the chuck jaws and
rotate the front section in the opposite direction. Ensure
the drill bit is in the center of the chuck jaws. Finally, firmly
rotate the front chuck section in the opposite directions.
Your drill bit is now clamped in the chuck.
7. TORQUE ADJUSTMENT (See Fig. I)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment
ring. The torque is greater when the torque adjustment
ring is set on a higher setting. The torque is less when the
torque adjustment ring is set on a lower setting.
28
SAFETY AND OPERATING MANUAL
" (lever is moved to the right) to remove