inventiv 202067 Mode D'emploi page 27

202067 CORDLESS DRILL 14.4V
3. TO REMOVE OR INSTALL BATTERY PACK(See Fig B)
Depress the battery pack release button to release and
slide the battery pack out from your tool. After recharge,
slide it back into your tool. A simple push and slight
pressure will be sufficient.
OPERATION
1. ON / OFF SWITCH (See Fig. C)
Depress the On/Off switch to start and release it to stop
your drill.
The on/off switch is fitted with a brake function which
stops your chuck immediately when you quickly release
the switch.
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed
is controlled by the amount of switch trigger depression.
WARNING:
Do not operate for long periods at low speed because
excess heat will be produced internally
2. SWITCH LOCK (See Fig. D)
The switch trigger can be locked in the OFF position. This
helps to reduce the possibility of accidental starting when
not in use. To lock the switch trigger, place the rotation
control in the center position.
3. REVERSIBLE (See Fig. E1, E2)
For drilling and screw driving use forward rotation marked "
" (lever is moved to the left). Only use reverse rotation
27
SAFETY AND OPERATING MANUAL