While Operating; Rules For Safe Operation; Other Safety Warnings - Troy-Bilt SUPER BRONCO TB415CS Manuel De L'utilisateur

Désherbeuse à gaz à 4-temps
Masquer les pouces Voir aussi pour SUPER BRONCO TB415CS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

READ ALL INSTRUCTIONS BEFORE OPERATING
• Read the instructions carefully. Be familiar with the controls
and proper use of the unit.
• Do not operate this unit when tired, ill, or under the influence
of alcohol, drugs, or medication.
• Children and teens under the age of 15 must not use the
unit, except for teens guided by an adult.
• All guards and safety attachments must be installed properly
before operating the unit.
• Inspect the unit before use. Replace damaged parts. Check
for fuel leaks. Make sure all fasteners are in place and
secure. Replace parts that are cracked, chipped, or
damaged in any way. Do not operate the unit with loose or
damaged parts.
• Carefully inspect the area before starting the unit. Remove
all debris and hard or sharp objects such as glass, wire, etc.
• Be aware of the risk of injury to the head, hands and feet.
• Clear the area of children, bystanders, and pets. At a
minimum, keep all children, bystanders, and pets outside a
50 feet (15 m.) radius; there still may be a risk to bystanders
from thrown objects. Bystanders should be encouraged to
wear eye protection. If you are approached, stop the unit
immediately.
• Use only 0.105 inch, 2.667 mm diameter original equipment
manufacturer replacement line. Never use metal-reinforced
line, wire or rope. These can break off and become
dangerous projectiles.
• Squeeze the throttle control and check that it returns
automatically to the idle position. Make all adjustments or
repairs before using unit.
SAFETY WARNINGS FOR GAS UNITS
WARNING:
Gasoline is highly flammable, and its
vapors can explode if ignited. Take the following
precautions:
• Store fuel only in containers specifically designed and
approved for the storage of such materials.
• Avoid creating a source of ignition for spilled fuel. Do not
start the engine until fuel vapors dissipate.
• Always stop the engine and allow it to cool before filling the
fuel tank. Never remove the fuel tank cap or add fuel when
the engine is hot. Never operate the unit without the fuel cap
securely in place. Loosen the fuel tank cap slowly to relieve
any pressure in the tank.
• Add fuel in a clean, well-ventilated outdoor area where there
are no sparks or flames. Remove the fuel cap slowly, and
only after the engine stops. Do not smoke while fueling.
Wipe up any spilled fuel from the unit immediately.
• Avoid creating a source of ignition for spilled fuel. Do not
start the engine until fuel vapors dissipate.
• Move the unit at least 30 feet (9.1 m) from the fueling source
and site before starting the engine. Do not smoke. Keep
sparks and open flames away from the area while adding
fuel or operating the unit.

WHILE OPERATING

• Never start or run the unit inside a closed room or building.
Breathing exhaust fumes can be fatal. Operate this unit only
in a well-ventilated outdoor area.
• Wear safety glasses or goggles that meet ANSI Z87.1
standards and are marked as such. Wear ear/hearing
protection when operating this unit. Wear a face or dust
mask if the operation is dusty.
• Wear heavy long pants, boots, gloves and a long sleeve
shirt. Do not wear loose clothing, jewelry, short pants,
sandals or go barefoot. Secure hair above shoulder level.

RULES FOR SAFE OPERATION

• IMPORTANT SAFETY INSTRUCTIONS •
• The cutting attachment shield must always be in place while
• This unit does not have a clutch. The cutting attachment
• Adjust the handle to your size in order to provide the best
• Be sure the cutting attachment is not in contact with anything
• Use the unit only in daylight or good artificial light.
• Avoid accidental starting. Be in the starting position
• Use the right tool. Only use this tool for its intended purpose.
• Do not overreach. Always keep proper footing and balance.
• Always hold the unit with both hands when operating. Keep a
• Keep hands, face, and feet at a distance from all moving
• Do not touch the engine, gear housing or muffler. These
• Do not operate the engine faster than the speed needed to
• Always stop the engine when cutting is delayed or when
• If you strike or become entangled with a foreign object, stop
• Stop the unit, switch the engine to off, and disconnect the
• Use only original equipment manufacturer replacement parts
• Keep unit clean of vegetation and other materials. They may
• To reduce fire hazard, replace a faulty muffler and spark

OTHER SAFETY WARNINGS

• Never store a fueled unit inside a building where fumes may
• Allow the engine to cool before storing or transporting. Be
• Store the unit in a dry area, locked up or up high to prevent
• Never douse or squirt the unit with water or any other liquid.
• Keep these instructions. Refer to them often and use them to
2
operating the unit as a trimmer. Do not operate unit without
both trimming lines extended, and the proper line installed.
Do not extend the trimming line beyond the length of the
shield.
continues rotating when the engine is idling. If it does not,
have the unit adjusted by an authorized service technician.
grip.
before starting the unit.
whenever pulling the starter rope. The operator and unit must
be in a stable position while starting. Refer to
Starting/Stopping Instructions.
firm grip on both handles or grips.
parts. Do not touch or try to stop the cutting attachment
when it rotates.
parts get extremely hot from operation, even after the unit is
turned off.
cut, trim or edge. Do not run the engine at high speed when
not cutting.
walking from one cutting location to another.
the engine immediately and check for damage. Do not
operate before repairing damage. Do not operate the unit
with loose or damaged parts.
spark plug for maintenance or repair.
and accessories for this unit. These are available from your
authorized service dealer. Use of any unauthorized parts or
accessories could lead to serious injury to the user, or
damage to the unit, and void your warranty.
become lodged between the cutting attachment and shield.
arrestor. Keep the engine and muffler free from grass, leaves,
excessive grease or carbon build up.
reach an open flame or spark.
sure to secure the unit while transporting.
unauthorized use or damage, out of the reach of children.
Keep handles dry, clean and free from debris. Clean after
each use, see Cleaning and Storage instructions.
instruct other users. If you loan someone this unit, also loan
them these instructions.
SAVE THESE INSTRUCTIONS

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pony tb465ss

Table des Matières