Team kalorik TKG SKV 1004 N Mode D'emploi page 13

ASSEMBLING THE VACUUM CLEANER
• Unpack the device and all accessories.
• Make sure that all parts mentioned in the manual are present and undamaged.
• Carefully secure the handle (8) to the main unit. To do this, carefully pull on the
supplied locking screw (9) (Ill. 4, Fig. 1).
• Insert the hand vacuum cleaner (4) into the main unit. For this, the device must always
be switched off. Pay attention to the "click" sound when snapping in (Ill. 4, Fig. 3). Make
sure that there are no substances between the contacts of the handpiece (4) and the
main unit,
• Charge the battery in the following situations:
Before first use; in this case, the battery must be fully charged (6-8 hours).
-
After a long period without use. (For optimal battery life, we recommend
-
charging the device at least every three months.)
• To load, the hand vacuum cleaner (4) must be inserted in the main unit (Ill. 5, Fig. 4).
• Plug the mains adapter of the charging cable (14) into a socket (Ill. 5, Fig. 5). Connect
the charging cable (14) to the charging port (10) of the main unit (Ill. 5,Fig. 6). Make
sure that the contacts on the charging cable and the vacuum cleaner are clean. If
necessary, remove the charging cable and clean the connectors.
• The charge indicator (4) turns red while the battery is charging (Ill. 5, Fig. 7) and turns
to blue when the battery is fully charged.
• Both the charging cable and the vacuum cleaner may become warm while charging.
This is completely normal.
• If you use the hand vacuum cleaner for a long period of time, the batteries can also
warm up here. This is also completely normal.
Note: For best performance, it is recommended to charge the vacuum cleaner after each
use.
USE
• Do not use the product while it is charging.
• Never touch the rotating parts of the floor brush during operation.
• Remove the water tank (Ill. 6) by first using the switch (11) and opening the water tank
casing (12). Remove the water tank (3) using the handle (2). Open the locking clips
(5) and remove the lid (4).
• Pour clean water in the tank, up to the mark.
• Close the lid (4) again and put the water tank (3) back into the main unit.
• Press the on / off switch (1) on the handle (8) of the main unit to switch on the device.
Use the ECO switch (2) to change the speed levels.
• Press the on / off button (1) again to switch off the appliance.
• During short breaks, you can stop the vacuum cleaner by tilting the appliance
slightly forward.
• The floor brush is suitable for the daily cleaning of larger surfaces, hard and smooth
floors or carpets.
• The hand vacuum cleaner is suitable for mattresses, sofas, curtains and wallpapers.
Press the release button (3) on the main unit to remove the handle (4) (Ill. 7, Fig. 8).
Switch on the device by pressing the on / off switch (5) on the hand vacuum cleaner.
• Never use the hand vacuum cleaner to vacuum water or other liquids.
13 TKG SKV 1004 N