LG LSSG3016ST Manuel Du Propriétaire page 57

56 TROUBLESHOOTING
Symptoms
Too much soil in the oven. Open the windows to get rid of the smoke from the
Too much smoke
room. Turn the oven mode knob to select Self Clean. Wait until the light goes off
during the Self Clean
before trying to open the oven door. Wipe up the excess soil and reset the clean
cycle.
cycle.
The oven door does
not open after a Self The oven temperature is too high. Wait up to one hour for it to cool down.
Clean cycle.
• Incorrect oven control settings. See Self Clean in the MAINTENANCE section.
The oven door is
• The oven was heavily soiled. Clean up heavy spills before beginning the Self
not clean after a Self
Clean cycle.
• The self clean cycle has been selected, but the door is not closed.
Clean and door flash
in the display
"Loc" message
The oven door is locked because the temperature inside of the oven is too high.
appears when you
Press and hold Probe for three seconds.
want to cook.
• Check the main gas shut-off valve or
Oven control beeps
and displays an F
• Remove the power from the range
error code.
The oven racks were
Apply a small amount of vegetable oil to a paper towel and wipe the edges of the
cleaned in a Self
oven racks. Do not use lubricant sprays.
Clean cycle.
Power outage or surge. Reset the clock. If the oven was in use, you must reset
Clock is flashing. it by pressing the oven mode knob to the Off position. Reset the clock and any
cooking function.
"Burning" or "oily"
This is normal in a new oven and will disappear with use. To speed the process,
odor emitting from the
set a Self Clean cycle for a minimum of three hours. See Self Clean in the
vent. MAINTENANCE section.
An odor from the insulation around the inside of the oven is normal for the first few
Strong odor.
times the oven is used.
• A convection fan may automatically turn on and off.
Fan noise
It is normal for the fan to operate periodically throughout a normal bake cycle in the
Fan operation
oven. This is to ensure even baking results.
Burners are not
lighting properly after Make sure that the burner heads and caps are completely dry and properly
cleaning the cooktop positioned.
surface.
When lighting just one
burner, clicking noise This is normal. Electric spark igniters from the burners cause the clicking noise. All
is heard from all the the spark igniters on the cooktop will activate when igniting just one burner.
burners.
All manuals and user guides at all-guides.com
Possible Cause / Solutions
Clean cycle. Heavily soiled ovens may need either a longer Self Clean or two
Self Clean cycles.
- Close the oven door.
the oven gas shut-off valve and call
for service.
for five minutes and then reconnect
the power. If the function error code
repeats, call for service.
- This is normal.
CODE CAUSE
F-3 Key short error
F-9 Oven not heating