Before Use; Spray Technique - Pattfield Ergo Tools PE-20 FSP Traduction De La Notice Originale

BEFORE USE

1 Unscrew the container 8, put it on a
sheet of paper and pour in the prepared
coating material.
ATTACH BATTERY
1 Slide the battery 6 (not included) onto
the tool until it snaps into place.
Caution! Only use the tool with the
batteries specified in technical data.

SPRAY TECHNIQUE

1 Hold the gun evenly and steadily at a
distance of approx. 10-30 cm from the
target object.
CLEANING
1 Fill the container 8 with water or sol-
vent (flashpoint over 55 °C). Assemble
the gun and spray the content into a
cloth or container until the emerging
liquid is clear.
3 Unscrew the union nut 14, remove air
cap 12, pull out nozzle 13 and clean
with solvent or water.
Caution! Never immerse the rear
part of the spray gun into liquids.
Only clean with moistened cloth.
138 EN
2 Align the feed tube 9:
1. For overhead objects
2. For objects lying below
2 To release the battery 6, press the bat-
tery release switch 5 and slide off the
battery.
2 Unsteady movements will cause a
heavy spray fog build-up and result in
an uneven surface quality
2 The spray gun can be dismounted for
cleaning. Press the unlock-button 15
and pull out the spray unit 10.
Caution! Make sure the battery is
removed before dismounting and
cleaning.
4 Change the air filter 1 whenever it is
soiled.
Caution! Never operate the spray
gun without filter!
1
1
1
1
3
2
1. 1. 2. 2.
2
2
2
4
EN 139