Warn W2030F Instructions D'installation page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Failure to observe these instructions could lead to minor to moderate injury.
• Always disconnect battery ground before working on lights.
• Always insure power is off, before cleaning, detaching and installing.
• Never turn on the bulb outside of the light body.
• Always avoid areas where flammable or burnable items are present.
• Always ensure the bulb connector is locked securely.
Failure to observe these instructions could lead to minor or moderate injury.
• Always use only the specified bulb.
• Never touch the lamp during or immediately after use with finger or bare skin.
• Never touch the glass part of the bulb.
• Never drop, bump or apply unnecessary force to any part of the WARN light system.
• Never pull or tug on harness.
Lamp Replacement: W650F and W650D
1. Disconnect battery ground (-) cable from battery.
2. Disconnect the electrical wires from the rear of the light.
3. Remove the Stone Guard.
4. Loosen the two screws on the sides of the lamp housing.
5. Remove the lens retainer ring from the light.
6. Remove the lens from the light housing. It may be necessary to gently pry it up from screws.
7. Release the bulb retainer clip from the flanges on back of reflector.
8. Replace the Bulb. Note the indexing on the Bulb and the Reflector. The Bulb can only be installed one way.
9. Do not touch the glass portion of the Bulb with your fingers. The oil from your skin can discolor the Bulb and
shorten Bulb life.
10. Replace the bulb retainer clip under the flanges on back of reflector.
11. Reverse the order of the previous steps to re-assemble.
12. Snap the Stone Guard in place.
13. Reconnect the electrical connections.
Lamp Replacement: W350F
1. Disconnect battery ground (-) cable from battery.
2. Disconnect the electrical wires from the rear of the light.
3. Remove the Stone Guard and o-ring by turning CCW until it stops then pull it off.
4. Remove the lens from the light housing.
5. Release the bulb retainer clip from the flanges on back of reflector.
6. Replace the Bulb. Note the indexing on the Bulb and the Reflector. The Bulb can only be installed one way.
7. Do not touch the glass portion of the Bulb with your fingers. The oil from your skin can discolor the Bulb and
shorten Bulb life.
8. Replace the bulb retainer clip under the flanges on back of reflector.
9. Reverse the order of the previous steps to re-assemble.
10. Reinstall the Stone Guard and O-ring by sliding it on and rotating CW until it locks/stops.
11. Reconnect the electrical connections.
WARN
INDUSTRIES
®
CAUTION
Electrical and Burn Hazard
Read installation and operating instructions thoroughly.
CAUTION
Burn and Fire Hazard
Read installation and operating instructions thoroughly.
NOTICE
Equipment Damage
Read installation and operating instructions thoroughly.
PAGE 5
82408A1

Publicité

Table des Matières
loading

Produits Connexes pour Warn W2030F

Ce manuel est également adapté pour:

W350fW650fW650dW400d-hidW700d-hid

Table des Matières