Battery Capacity Indicator - Horizon Hobby Dynamite Prophet DYNC2025 Manuel D'utilisation

oPErATINg YoUr ChArgEr
Instructions are provided for one channel.
The same applies for the other channel.
1. Use the Battery Type Switch to select the battery type (Ni-MH/
Li-Po/Li-Po Fast) for the battery you wish to charge. The 4-Digit LED
Indicator will display the battery type for 2 seconds, then show the
charge current selected by the Charge Current Dial.
2. Select the charge current (0.1A–6.0A) by rotating the Charge Current
Dial. The 4-Digit LED Indicator will display the charge current.
3. Connect the banana plugs of the battery adapter cable to the Power
Output Black (-) and Power Output Red (+) , making sure that the
positive and negative connectors are not reversed.
4. If charging a Li-Po battery, connect the JST_XH Balance adapter to the
Balance Circuit Adapter Board Connector, then connect the balance
connector of the battery to the JST_XH Balance adapter. A 1S battery
will not have a balance connector.
5. Connect the battery to the battery adapter cable.
6. Press and hold the Start/Stop Button for 3 seconds to begin
charging. If there is no error, charging will begin.
7. Press and hold the Start/Stop Button for 3 seconds at any time to
stop charging.
8. When charging is complete, disconnect the battery from the charger.
CAuTION: When connecting the battery to the charger, always
connect the battery charger power outlet lead and the battery
balance lead to the same channel.
LI-Po BATTErY FAST ChArgINg
If you intend to use your battery for casual sport use rather than racing,
you may want to select Li-Po Fast charging. Fast charging does not
balance the individual cells of the battery as precisely as normal charging,
but the charge cycle is completed faster. This MAY lower the performance
or speed of your vehicle slightly, but it is likely you will not notice this in
normal operation.

BATTErY CAPACITY INDICATor

When charging begins, the 4-Digit LED Indicator will cycle back and
forth between the currently selected battery type and the capacity data
"0000". After 30 seconds, the 4-Digit LED Indicator will only show the
battery capacity. The battery capacity value (in mA) shown on the display
will continue to increase as the charge cycle progresses. When charging is
complete, it will display the final capacity added to the battery.
5
EN