Horizon Hobby Dynamite Prophet DYNC2025 Manuel D'utilisation page 6

EN
CELL VoLTAgE INDICATor
After 30 seconds of charging, you can push the Start/Stop Button once
to display the individual cell voltages in a 1–6S Li-Po battery. The 4-Digit
LED Indicator will cycle through the following sequence (actual values
shown will differ from this example):
0000 Present Charge Capacity
C6 Total Cells Present: 1 to 6
22.2 Total Pack Voltage: 3.7 to 25.2
C-1 First Cell
C-2 Second Cell
C-3 Third Cell
C-4 Fourth Cell
C-5 Fifth Cell
C-6 Sixth Cell
22.2 Total Pack Voltage: 3.7 to 25.2
0000 Present Charge Capacity
The cell voltage will only be displayed for the actual number of cells in the
battery. If you push the Start/Stop Button again during this sequence,
the 4-Digit LED Indicator will show the present charge capacity data
and resume normal operation.
The cell voltages can also be displayed at any time following the
completion of the charge cycle before the battery type is changed, the
battery is removed or another charge cycle is started.
3.70 First Cell Voltage
3.70 Second Cell Voltage
3.70 Third Cell Voltage
3.70 Fourth Cell Voltage
3.70 Fifth Cell Voltage
3.70 Sixth Cell Voltage
TroUBLEShooTINg
When an error occurs, the Red LED will blink and a beep will sound twice
per second 10 times. Once the alert has sounded 10 times, the Red LED
will glow solid and the 4-Digit LED Indicator will show the error condi-
tion that has been detected. Once the error condition has been resolved,
press and hold the Start/Stop Button for 3 seconds to reset the charger.
ERROR
PROBLEM
CONDITIONS
'-11-' Dead cell or imbalance between cells is too high (over
0.3V) for safe charging
'-22-' Polarity (+ and –) connections of battery are incorrect
for safe charging
'-33-' Battery not connected correctly
'-44-' Charger has become too hot for safe charging
'-55-'
Over-current or short-circuit condition on the battery
'-66-'
The Battery Type Switch was moved to a different
position during charging
'-77-' The DC input voltage is too high or low for safe
operation
'-88-' One cell of the battery pack is too high or too low for
safe charging
6