Lithonia Lighting LDN8 Mode D'emploi page 4

C) Lay-in Panel T-bar Ceiling Installation (Cont.)
7
Once the channel bars are in place, close
the cams to hold the position.
10
Complete necessary splices. Snap the door
onto the junction box.
13
Squeeze wire torsion springs on the light
engine and insert each leg of the spring
into the slots on the brackets on either
side of the opening in the mounting frame.
8
When the cams are in the closed position,
a wire tie can be wrapped through the
indicated holes to ensure the cam stays
closed.
Locking Screw
11
Align the opening in the trim with the tabs
on the light engine. Make sure the locking
screw on the light engine is loosened.
Push the trim onto the light engine
aligning the slot openings with the pins
and then rotate the trim clockwise until
slots bottom out on pins
14
Ensure wire torsion springs are installed as
shown to keep the light from falling. Pay
careful attention that the wire loops are
oriented as shown.
Lithonia Lighting
1400 Lester Road Conyers Georgia 30012
P 800 315 4982 F 770 860 3129
www.Lithonia.com
9
Remove knockouts on junction box to feed
power supply to fixture. Supply wire must
meet applicable electrical codes and be
rated for a minimum of 90°C.
12
Trim Slot
Once the trim is rotated into place, tighten
the indicated screw
© Acuity Brands Lighting, Inc. 2016
Locking Screw
CJ5201055 Rev. A
Page 4
.
All Rights Reserved