Lithonia Lighting LDN8 Mode D'emploi page 3

B) Important Safety Information - For Your Protection, Read Carefully
Warning: Risk of fire. Do not install fixture within 36" center to center of another luminaire, 18" from the center of the luminaire to the
nearest building member radially and 6" from the top of the luminaire to the nearest building member. Electric current can cause painful
shock or serious injury unless handled properly. For your safety, always remember the following:
• Turn off the supply power.
• Ground the fixture to avoid potential electrical shocks.
• Do not handle an energized fixture or energize any fixture with wet hands, when standing on a wet or damp surface, or in
water.
C) Lay-in Panel T-bar Ceiling Installation
1
8-3/4"
Hole
Cut ceiling opening slightly larger than the
outside diameter on the mounting frame.
8-3/4" (22.2 cm) diameter opening.
4
Position mounting frame through opening
in ceiling.
2
Cam
Assemble the channel bars to each side of the
of the mounting frame with the included
hardware. Leave the cams loose to adjust the
position of the frame in the ceiling.
5
Channel bar hooks
Hook channel bars over T-bar and secure
to T-bar by means of wire ties.
Lithonia Lighting
1400 Lester Road Conyers Georgia 30012
P 800 315 4982 F 770 860 3129
www.Lithonia.com
3
Adjust channel bars to the correct spacing
between T-bar. See Page 4 for procedure
for non-accessible ceiling installation.
6
Mounting Frame
1/8" Max
Ceiling Line
Adjust the mounting frame vertically to
align the bottom edge of the draw-down
to either flush or slightly above (1/8" max)
the ceiling line.
CJ5201055 Rev. A
© Acuity Brands Lighting, Inc. 2016
All Rights Reserved
Draw-down
Page 3
.