Installing Batteries In The Remote Control; Quicktips - Sanyo CLT1554 Manuel D'instructions

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Getting Started

QuickTips

The TV will automati-

■

cally select the correct

Antenna mode for the

type of RF signal you

connect.

TV will switch off

■

automatically after 15

minutes if there is no

signal reception (cable

out or station not

broadcasting).

Exception—When

the Video mode is

selected, the TV will

not automatically

switch off when signal

reception has stopped

for 15 minutes.

If you move the TV to

■

a new location, press

the RESET key twice

after connecting the

signal and turning on

the TV.

Need help?

Visit our Web site at

www.sanyoctv.com

or Call 1-800-877-5032

Operational Tip for No Signal Connection:

If the TV is used as a monitor only, with a DVD player or some other type of external equipment, and no cable or

antenna signal is available, the following setup is necessary:

Your TV is designed to automatically search for available channels. Therefore, the initial start up requires that you press

the MENU key, enabling the TV to automatically go through the channel search process before you can operate the

TV. After the initial channel search is completed, you must press the MENU key again to complete the channel search

process, it will take a few minutes for the TV to complete searching.

After channel search is complete (2 searches), you can press the INPUT key on the remote control to use the TV as a

monitor.

CATV FRANCHISE NOTE: Cable companies, like public utilities, are franchised by local government authorities. To receive cable programs,

even with equipment which is capable of receiving cable channels, the consumer must subscribe to the cable company's service.

Installing Batteries / Signal Connection: Cable, Antenna, or Satellite Receiver