Haier GE UAWB47A Instructions D'installation

Les langues disponibles

Télécharger ce manuel

Before you begin installation, read these instructions completely and carefully.

Observe all governing codes and ordinances as they may apply.

Leave these instructions with the owner.

IMPORTANT SAFETY NOTICE

is to be installed only by a licensed and trained industry professional. The manufacturer will not

assume liability for unqualified installers or failure to follow these instructions.

WARNING

For personal safety, disconnect system power before installing this accessory.

During installation, if ground wires, screws, straps, clips, or other means of attaching grounding

components are removed, they must be returned to their original positions and fastened securely.

Model: UAWB47A

Parts Included:

• Wind baffle (2 parts)

• 8 stainless self-tapping screws

• 4 screw covers

• This instruction sheet

Step 1:

Use supplied screws to mount the baffle onto the unit using the factory drilled holes.

Baffle mount holes

To avoid personal injury or property damage, this accessory

Installation Instructions

Wind Baffle

31-5000697 Rev. 0 04-22 GEA

Page 1 Installation Instructions Wind Baffle Before you begin installation, read these instructions completely and carefully. Observe all governing codes and ordinances as they may apply. Leave these instructions with the owner. IMPORTANT SAFETY NOTICE To avoid personal injury or property damage, this accessory is to be installed only by a licensed and trained industry professional.
Page 2 Installation Instructions Wind Baffle Step 2: Drive 3 screws through the front of the wind baffle where the two pieces overlap. This will eliminate any vibration rattle during operation. Cover the ends of the screws with the supplied caps to prevent any injury when reaching down between the baffle and the grille.
Page 3 Instructions d’installation Coupe-vent Avant de commencer l’installation, veuillez lire ces instructions attentivement et en entier. Observez tous les codes et règlements pertinents en vigueur. Remettez ces instructions au propriétaire. IMPORTANT SAFETY NOTICE Afin de prévenir les blessures et les dommages à la propriété, cet accessoire doit être installé...
Page 4 Installation Instructions Wind Baffle Étape 2: Vissez 3 vis dans l’avant du coupe-vent, là où les deux parties se chevauchent. Cela éliminera tout bruit de vibration pendant le fonctionnement. Couvrez les extrémités des vis avec les capuchons fournis pour prévenir toute blessure lorsque vous étendez la main entre le coupe-vent et la grille.