Kolpin 2007 Installation

*CAREFULLY READ INSTRUCTIONS AND ALWAYS PROTECT YOUR MACHINE DURING INSTALLATION OF WINDSHIELD*
Item Name
1 Windshield
2 Clamp kit (A)
3 Clamp kit (B)
4 Nuts & bolts kit
5 Vent grill
Vent grill attachment
6
kit
7 Bumpon
Step 1:
Assemble the vent grill to the windshield as shown.
Step 2:
Attach 5 clamps onto the front roll-bar of the machine as shown. Do not tighten clamps until windshield is fully assembled.
Step 3:
Attach the windshield to clamps as per drawing. Adjust position of all components, and then tighten all screws and nuts. Stick
two bumpons onto the hood as per pictures, this will minimize windshield vibration.
Screw M8x30
Washer M8
Shoulder
washer M8
*Care and cleaning: Do not use ammonia or any other cleaning chemical.*
2007 - Polaris Ranger RZR Full vent windshield installation instructions rev.00
Includes: 2 complete clamps with 2 socket cap screws M8x35, 2 lock washers M8 and 2 locknuts M8
Includes: 1 complete clamps with 1 socket cap screws M8x35, 1 lock washers M8 and 1 locknuts M8
Includes: 5 screws M8x30 with 10 washers M8, 5 shoulder washers and 5 locknuts M8
Includes: 3 carriage bolts M6x30 with 3 thin plastic washers, 6 x plastic washers M6,
Washer M8
Locknut M8
*Avoid using an abrasive cloth.*
INSTALLATION STEPS
POLARIS RANGER RZR
FULL WINDSHIELD WITH VENT GRILL
PARTS LIST
Description
Windshield cut-out made of 1/4" GE polycarbonate MR10
Black grill
3 rubber washers M6 and 3 knob M6
Includes: 2 rubber bumpons
Plastic washer M6
Knob M6
Clamp
Male part
Locknut M8
PART #2007
Rubber washer M6
WWW.KOLPIN.COM
Qty
1
2
1
1
1
1
1
Carriage bolt M6x30
Thin plastic washer
Vent grill
Plastic washer M6
Socket cap
screw M8x35
Lock washer
m8
Clamp
Female part
Bumpon
Page 1