Chicco TIRALATTE ELETTRICO Mode D'emploi page 25

Trouble
The breast pump does not pump or
pumps very little.
Milk expression is painful.
The breast pump does not switch on
TECHNICAL SPECIFICATIONS
- 00009199300000 ELECTRIC BREAST PUMP Model N0041 and
- Maximum vacuum level in extraction mode: -0.35 ± 0.03 bar**
(** measured using a sample cylinder - confidence level 95%).
- Type of appliance: intermittent operation; 30 minutes ON - 30 minutes OFF
- Motor body weight: 325 g excluding batteries
- Dimensions: 98x70xh105 mm
- Made in China
BATTERY POWERED MODE:
6V DC – 4x1.5V AA size (LR06) batteries
DECLARATION OF EC COMPLIANCE
The Chicco-branded appliances Electric Breast Pump 000091993000000 Mod. N0041 Double Electric Breast Pump
000091994000000 Mod. N0000 comply with all the essential requirements and other provisions indicated in the EU Di-
rectives 2014/30/EU (electromagnetic compatibility), 2014/35/EU (Low Voltage), and 2011/65/EU (RoHS). A copy of the EC
declaration can be requested from the manufacturer: Artsana S.p.A via Saldarini Catelli, 1 - 22070 Grandate (Como) Italy.
The products Electric Breast Pump
Pump 000091994000000 Mod. N0000 comply with EU Directive 2012/19/EU.
The crossed bin symbol on the appliance indicates that the product, at the end of its life, must be disposed of
separately from domestic waste, either by taking it to a separate waste disposal site for electric and electronic
appliances or by returning it to your dealer when you buy another similar appliance. The user is responsible for
Cause
Valve not assembled or not properly
assembled.
Cup and motor body not assembly
correctly.
The cup does not fit well on the breast
Suction level not correctly adjusted.
Run-down and/or insufficiently
charged batteries.
Suction level too high.
Failure of mains adaptor and/or
appliance.
Incorrect connections.
Run-down batteries.
00009199400000 DOUBLE ELECTRIC BREAST PUMP N0000
000091993000000 Mod. N0041 and Double Electric Breast
25
Solution
Assemble the valve correctly.
Check that you have performed
the procedure described in the
"PREPARATION" paragraph correctly.
Make sure that the silicone tube is
firmly connected to both the motor
unit and the membrane cover.
Check that the tube is not damaged.
Do not twist the tube during milk
expression.
Fit the pump body over your breast,
taking care that your nipple is
properly centred. Try with/without
the soft silicone cover.
Change the suction level until
you achieve more comfortable
stimulation and suction by pressing
the "+" or "-" buttons.
Replace the batteries.
Change the suction level until
you achieve more comfortable
stimulation and suction by pressing
the "-" button.
Check that mains power is present.
Check the position of the batteries in
the battery compartment.
Check all the connections.
Replace the batteries.