Français – voir p. 17
Installation considerations
•
For best results, Hansgrohe recom-
mends that this unit be installed by a
licensed, professional plumber.
•
Please read over these instructions
thoroughly before beginning installa-
tion. Make sure that you have all tools
and supplies needed to complete the
installation.
•
This product is listed by IAPMO and is
approved for use in Massachusetts.
Tools required
The following tools are suggested for installing the showerpanel:
•
Tape measure
•
Level
•
Grease pencil or other marking device
•
Drill with 6 mm bit suitable for wall
surface
•
10 mm nut driver
•
10, 11 and 19 mm wrenches
Check package contents
Before beginning installation, check the contents of this package. Make sure that all parts
are present and in good condition. If any part is missing or damaged, please contact
Hansgrohe Customer Service before proceeding.
•
Protection against backflow provided
by check valve in the handshower
outlet.
•
The high temperature limit stop on the
thermostatic mixing valve may be reset
to comply with local plumbing codes*
-- see page 13.
*In Massachusetts, the maximum output temperature
cannot exceed 112°F.
•
3 mm Allen wrench
•
Philips screwdriver
•
Waterproof sealant
•
Mallet (to install anchors)
•
Teflon tape
English
3