Qlima SPHP 130 Manuel D'utilisation page 41

Masquer les pouces Voir aussi pour SPHP 130:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

LOCATION
The heat pump should be located at least 2.5 meter away from the swimming pool.
Please comply with the following rules concerning the choice of heat pump location.
1.
The unit's future location must be easily accessible for convenient operation and maintenance.
2.
It must be installed on the ground, laid ideally on a level concrete floor. Ensure that the floor is suffi-
ciently stable and can support the weight of the unit.
3.
Check that the unit is properly ventilated, that the air outlet is not facing the windows of neighboring
buildings and that the exhaust air cannot return. In addition, provide sufficient space around the unit
for servicing and maintenance operations.
4.
The unit must not be installed in an area exposed to oil, flammable gases, corrosive products, sulfurous
compounds or close to high frequency equipment.
5.
To prevent mud splashes, do not install the unit near a road or track.
6.
To avoid causing nuisance to neighbors, make sure the unit is installed so that it is positioned towards
the area that is least sensitive to noise.
7.
Keep the unit as much as possible out of the reach of children.
Place nothing less than 1,50 m in front of the heat pump.
Leave 30 cm of empty space around the sides and rear of the heat pump.
Do not leave any obstacle above or in front of the unit!
Q_man_SPHP 130 ('21) V6.indd 41
Q_man_SPHP 130 ('21) V6.indd 41
4
41
21-12-20 14:15
21-12-20 14:15

Publicité

Table des Matières
loading

Table des Matières