Instructions For Installation - Plamen Tara Instructions Techniques

It is also necessary for the combustion of wood, so that the unburned carbon can undergo another
process of subsequent combustion.
During the wood burning process, the air regulator must be slightly open, otherwise the wood will
burn quickly and the furnace may overheat. The secondary airflow direction regulator is located
above the firebox door.

2 INSTRUCTIONS FOR INSTALLATION

The stove installation has to be performed in accordance with all the valid standards, laws and
regulations. We advise you to ask your chimney sweeper to supervise and check the stove
installation, as well as the sufficient airflow required for combustion process. We recommend the
use of standard flue pipes and elbows with flap valves. The flue pipes have to be fixed securely
and tightly to the stove flue and to the chimney.
When installing the stove the following safety measures are to be observed:
a) minimal requirements for safe distance of the rear and lateral space from flammable and
objects sensitive to heat (e.g. furniture, wood surfaces, fabrics, etc.) (see Illustration 4A) in order
to secure sufficient heat isolation. All minimal safety distances are brought on the enameled plate
and are not to be modified.
b) no flammable or fire sensitive objects and materials are to be placed nearer than the 120 cm
distance in front of the stove.
c) if the stove is to be placed on a flammable base, the base should be secured with a non-
flammable one, e.g. a steel base. This type of base has to protrude at least 60 cm in the front and at
least 40 cm on the lateral sides, taking into consideration additional space for opening the front
door (Illustration 4B).
Recommended minimum distance from non-flammable surfaces is 300 mm.
In case the pipe connection crosses over sections made of flammable objects, all of them have
to be replaced by temperature-resistant materials in the radius of 20 cm around the pipe.
Image 4A
21
Image 4B