Keypad And Display - geo-FENNEL FLM 400 Data Mode D'emploi

KEYPAD AND DISPLAY

3
4
5
7
6
8
9
10
12
11
13
1
OPERATION
CONNECT THE PHOTO DETECOR
Before starting the operation connect the photo detecor supplied in the kit with the socket on top of the
instrument housing. Remove the protective cover before starting any operation.
ON/OFF
Power on and off the instrument with the ON/OFF button.
Remove the lens protection and face the instrument to the light source in a horizontal position.
UNITS
Select the unit required Lux or Foot-candle (Fc) with the button UNITS. Set the measuring range with
the button APO.
1. ON / OFF button
2. Photo detector
3. Connection of the photo detector
4. LC display
2
5. USB port
6. UNITS: Selection of the unit (Lux or Fc)
7 . RANGE / APO: Selection of the measuring range
8. BACKLIGHT / LOAD: Backlight / loading of data
9. REC / SETUP: Save / settings
10. MAX / MIN: ∆ Maximum-Minimum / UP
11. REL /
12. PEAK /
13. HOLD /
: Relative reading / FORWARD
: HOLD peak value / BACKWARD
: HOLD values / DOWN
EN
C
D
13