MELICONI LOGIC 12 Mode D'emploi page 31

Thanks to the LEARN function, the LOGIC12 remote control can pick up the infrared signal produced
from any of the buttons on an original functioning remote control, store it on its own selected buttons
and then reproduce it as it pleases with pressure on the pre-selected button.
In order to use this function, the remote control whose signal you wish to copy
1. Learn about the missing functions on an original remote control and store them in the spaces on the
user personalisable page, or on a normal button on the remote control, possibly replacing a pre-
existing command.
2. Learn all the functions on the new remote control not yet inserted in the database of the
universal remote control.
NOTE: the maximum number of functions that can be learned is 85.
Learn the missing functions on an original remote control
A
The most important thing if you wish to acquire the signals is to set the correct
1. Place the original remote control in front of the
LOGIC12, so that the areas that give off the
infrared signals are one in front of the other at a
distance of about 5 cm.
2. Press the LEARN button for a second:
the writing "TRY" will appear at the top of the
screen for about 10 seconds. Within ten seconds,
press and keep pressed down any one of the
buttons on the original remote control. The green
LED at the top should start to flash; if this is not
the case, then bring the remote controls closer
together.
3. Gradually increase the distance between the
two remote controls, taking care not to lose the
alignment between them, up to the point when
the green LED stops flashing.
At this point you will have the maximum distance of data exchange between the two remote controls.
In order to acquire the signals you will have to position the remote controls at half
this distance taking care not to move them until the process is complete.
4. Press the USE button and select the kind of
appliance that you want to operate (TV, VCR,
DVD, PAY TV ...). Then identify the button on
which you want to acquire the function from the
original remote control (we recommend that you
use one of the free buttons on the user display,
accessible by keeping the PAGE button pressed
down for a few seconds. If you want to use a
different display, select it by quickly pressing
the PAGE button).
LEARNING FUNCTION (LEARN)
must be working.
Thanks to this function, it is possible to:
and store them on any LOGIC12 button
distance between the remote controls:
5 cm
LEARN
max dist.
USE
(e.g. TV 1)
PAGE
29