MELICONI LOGIC 12 Mode D'emploi page 30

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 3
Check that some other key, corresponding to the one on your original remote control, is also wor-
king. If the commands only work partially or are working strangely, it his highly probable that the
code found is not correct, but of a similar remote control. In this case repeat the research procedure
starting from point 2.
the remote control exits the programming and the light indicator stops flashing in the following
cases:
• if no key is pressed for 30 seconds
• if you press a key different from the ON/OFF or PLAY ones by mistake
• if the list of codes to be researched is finished. In this case, contact the call centre at 02
66012766.
In the normal functioning of the LOGIC12, in the top right hand corner of the LCD screen, the four digit
code of the appliance that is being controlled in that moment, is constantly visible.
LIGHT FUNCTON – Remote control keypad turned on
By pressing the LIGHT
LIGHT
This function is very useful for finding the right button to press in the dark in order to obtain the desired
function. The light goes off if the remote control has not been used for about 8 seconds or by pressing
the LIGHT button again.
HOW TO ACTIVATE ADDITIONAL COMMANDS
While not being indicated on the keypad, some buttons can transmit additional commands. Search
for them on your LOGIC12 remote control by pressing the buttons one after the other to find any other
commands that might be of interest to you.
For the less commonly used functions, you can search the additional commands on the
www.logicmeliconi.com site.
ACTIVATION AND PERSONALISATION OF
Normally, the universal remote controls only automatically reproduce the main functions of the remote
control that has been replaced. This is also the case with the LOGIC12 remote control.
The LOGIC12 however, like and more than the other Meliconi remote controls, allows you to:
1. recall and store at a later date any of the original functions on the remote controls that have been
replaced, that were not done automatically.
2. position them on a display expressly dedicated to this use (the USER DISPLAY) and associate them
in writing as you wish (maximum of 5 digits)
All this without the aid of the technical assistance, or long, complicated procedures, but in complete
autonomy and very easily. In order to carry out this kind of personalisation, follow the guidelines that
can be found on the www.logicmeliconi.com site.
TV AUDIO FUNCTIONS ALWAYS AVAILABLE
When you select an appliance that does not have its own volume controls, press the V+
and Mute
buttons and the volume of the appliance stored as TV 1 is controlled. For more
V-
detailed information connect to the www.logicmeliconi.com
28
CHECK
NOTE
VIEW OF CODE IN USE
button, the remote control keypad lights up immediately.
THAT DO NOT APPEAR ON THE KEYPAD
SUPPLEMENTARY FUNCTIONS
, V-
V+

Publicité

Table des Matières
loading

Produits Connexes pour MELICONI LOGIC 12

Table des Matières