Before You Begin - Kohler Vanity Instructions D'installation

Before You Begin

CAUTION: Risk of product damage. Do not modify the vanity. Doing so will
compromise structural stability.
CAUTION: Risk of personal injury or property damage. Select 500 lb (227
kg) load-bearing 5/16" lag bolts with a length to clear obstacles in the wall and
5/16" washers. Calculate the proper lag bolt length by adding the following:
1-1/2" (38 mm) backing material, plus the wallboard thickness, plus the back
rail thickness.
CAUTION: Risk of property damage. To properly support the weight of the
vanity and vanity top/sink, secure to stud framing or 2x6 support behind the
finished wall.
CAUTION: Risk of product damage. Use care when moving the cabinet to
avoid impacting, sliding, or side-loading the legs.
NOTICE: Siliconized acrylic caulk must be used to secure a sink or countertop to the
vanity. Do not use 100% silicone sealant, which will damage the finish of the vanity.
NOTICE: Any electrical accessory components must be connected to a circuit
protected by a Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD). Follow all local electrical codes.
Follow all local plumbing and building codes.
Your product may appear different than the one illustrated. The installation
procedure is the same.
Two people should perform this installation.
This vanity is designed to allow most base moldings to pass behind the vanity.
To ease installation, remove drawers from the vanity before beginning. Refer to the
section in this guide for proper removal.
Secure the vanity to stud framing. When possible, provide 2x6 bracing behind the
finished wall for additional support.
1216526-2-G
4 Kohler Co.