Before You Begin; Avant De Commencer - Kohler Kelston K-2515 Guide D'installation Et D'entretien

Masquer les pouces Voir aussi pour Kelston K-2515:
Table des Matières

Publicité

Tools/Outils/Herramientas
Plus/Plus/Más:
• Fasteners [Min 50 lb (22.68 kg) Load Bearing]
Fixations [capacité de charge min 50 lb (22,68 kg)
Siliconized Acrylic
Herrajes [para carga mín de 50 lb (22,68 kg)]
Caulk
• Framing Nails/Clous de cadrage/Clavos para estructuras de madera
Mastic acrylique
• 3/4" Plywood/Contreplaqué de 3/4"/Madera contrachapada de 3/4"
siliconé
• Plated Plumbing Fittings
Sellador de
Raccords plaqués de plomberie
acrílico siliconado
Conexiones de plomería enchapadas

Before You Begin

NOTICE: Siliconized acrylic caulk must be used to secure the lavatory to the vanity.
Do not use 100% silicone sealant, which will damage the finish of the vanity.
NOTE: Plumbing fittings will be exposed and visible once the vanity installation is
complete. Plated plumbing fittings are recommended.
Observe all local building codes.
Make sure the finished wall is straight and plumb, and the floor is flat and
perpendicular to the finished wall.
This vanity is designed to allow most base moldings to pass behind the vanity.
Remove any moldings that may inhibit the vanity from being flush against the
finished wall.
Remove the drawers from the vanity before beginning the vanity installation.
Doing so will ease the installation process. Refer to the "Service the Drawer"
section contained in this guide for proper removal.
Install the water supply and drain lines according to the roughing-in information.
The water supply nipples must extend 3" (7.6 cm) beyond the finished wall
material.
Kohler Co. reserves the right to make revisions in the design of products without
notice, as specified in the Price Book.

Avant de commencer

NOTICE: Mastic à l'acrylique siliconée doit être utilisé pour sécuriser le lavabo au
meuble. Ne pas utiliser du mastic à la silicone à 100%, cela endommagera la finition
du meuble.
REMARQUE: Les raccords de plomberie seront exposés et visibles une fois
l'installation du meuble complétée. Des raccords de plomberie plaqués sont
recommandés.
Respecter tous les codes de construction locaux.
S'assurer que le mur fini soit droit et d'aplomb, que le sol soit plat et
perpendiculaire au mur fini.
Kohler Co.
3
1105377-2-B

Publicité

Table des Matières
loading

Table des Matières