Nozzle Cleaning; Pump Oil Changing; Cleaning And Storage; Environmental Policy - VITO PRO-POWER VIML150HQA Mode D'emploi

Nozzle cleaning

A clogged nozzle (16) causes a significant reduction in
water flow, causing the washer's motor to run
intermittently. When it happens, perform the following
operations:
1. Turn the washer off with the "ON/OFF" switch (5) and
unplug the power cord (3) from the socket;
2. Close the water supply tap;
3. Press the gun trigger (20) to release the water
pressure;
4. Remove the lance (13);
5. Place the adjustable nozzle in the narrow spray
position (turn the spray pattern setting (16)
counterclockwise all the way);
6. Use the supplied cleaning needle. Insert the needle
inside the hole and move it forwards and backwards
until unclog;
7. Tap the lance vertically until the debris comes out at
the opposite end of the nozzle;
It is important that the nozzle is regularly inspected and
cleaned, using the supplied needle.

Pump oil changing

Pressure washer's water pumps need relatively low oil
maintenance.
However, in case of leak, stop the machine immediately
and call technical assistance.

Cleaning and storage

Cleaning
Clean the washer after each use. Careful handling
protects the power tool and extends its service life.
Storage
The appliance should be stored in a dry place, especially
in winter, to avoid damages cause by ice.
1. After stopping the washer, remove the water from
the pump, press the gun trigger (20) until there's no
water coming out of the nozzle (16);
2. Disassemble pressure hose, gun and lance;
3. Drain the water from all accessories and use a cloth
to clean external parts of hoses and other accessories;
4. Clean the water inlet filter and the nozzle;
5. Put the cover on the water inlet hose adapter of the
washer (1);
6. Store the appliance in a clean and dry place;
34

ENVIRONMENTAL POLICY

The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of power tools in your household
waste!
According to the European Directive 2012/19 /EC on
electrical and electronic equipment waste and its
transposition into national law, power tools must be
collected separately and delivered to the collection sites
provided for this purpose.
You can obtain information regarding the disposal of
the power tool through the person in charge for the
recycling in your city.

CUSTOMER SERVICE

Tel.: +351 256 248 826
E-mail: international@centrallobao.pt
Site: www.centrallobao.pt