Before You Start Working; While Operating; Maintenance And Cleaning - VITO PRO-POWER VIML150HQA Mode D'emploi

▪ The cross-section of the extension cord cables shall
be proportional to the length and with the same
characteristics as or larger than the washer's power
cord (1.5 mm² → L  25 m ; 2.0 mm² → 25  L  50
m);
▪ Do not use damaged extension cords. Examine the
extension cords condition before use and replace if
necessary;
▪ Always unplug the extension cord before removing
the plug from the power tool;

Before you start working

Individuals who have not read the instruction manual
and are not familiarized with how to operate the high-
pressure washer must not use it.
Before using the device, replace damaged and used
parts.
Check that all nuts and screws are properly tightened. It
is important to inspect regularly the equipment in order
to ensure safety issues and a good performance.
To ensure that you work with the power tool safely, you
should take into account a few precautions and
procedures before start-up:
▪ The washer's components and accessories are
assembled correctly;
▪ The safety devices are in perfect condition and work
properly. Never use the power tool if the safety
devices are missing, inhibited, damaged or worn out;
▪ The high-pressure hose, spray gun and coupling
accessories are in perfect conditions.
Make all adjustments and work necessary for the
correct assembly of the power tool if you have any
questions or difficulties, contact your official dealer.

While operating

Keep third parties away from the power tool's
area of operation. Never work while animals or
people, especially children, are in the danger zone.
Use the equipment with special caution when working
near slopes, ditches and wells. Place the equipment on
a firm and flat floor, at a safe distance from these
danger locations.
The control and safety devices installed in the power
tool must not be removed or inhibited.
30
Starting the washer
Switch on the power tool carefully following the
operating instructions. Using the device according to
these instructions reduces the risk of injury.
Do not cover the machine during operation or use it in
a room without adequate ventilation! To avoid the risk
of overheating the washer, keep the ventilation slots
permanently clean and unobstructed so that air can
circulate.
Do not expose the equipment to sunlight or use it for
long periods of time. Such conditions cause
overheating, which leads to a constant activation of the
device's thermal relay.
Operating the high-pressure washer with a supply
voltage lower than the recommended in the technical
specifications or using extension cords with a very long
cable can also cause a constant activation of the thermal
relay.

Maintenance and cleaning

Before performing cleaning, adjusting, repairing and
maintenance works, you should:
▪ Place the device on a firm, flat floor;
▪ The power cord must be unplugged from the socket.
Check the appliance frequently especially before
storage (e.g. before winter period), regarding wear and
damage.
Replace worn out or damaged parts immediately, so
that the power tool is always in a safe operating
condition.
Cleaning:
The power tool must be carefully cleaned after each
use.
Do not use aggressive cleaning products.
products may damage
compromising the safe operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out; all other works must be
performed by an official dealer.
These
plastics and metals,