Adjusting The Nailing Depth; Firing Lock; Maintenance; Jam Clearing - Powermate VX CRN175P Manuel De L'opérateur

When using the tool in cold conditions the tool will cycle
slower than usual while driving the first nails. The cycle rate
will increase as the tool warms up. Keep tool warm to avoid
reduced cycle rate.

ADJUSTING THE NAILING DEPTH

WARNING
Disconnect the tool from the air source before making
adjustments. Such precautionary safety measures reduce
the risk or unintentional tool operation.
1. Disconnect tool from air supply.
2. Remove nails from the tool.
3. Adjust tool driving depth:
• T o reduce the nail depth , turn the adjustment knob
counter clockwise (FIG 8).
• T o drive the nail deeper, turn the adjustment knob
clockwise (FIG 9).
4. Reload nails as described in the "Loading Nails" section
of this manual.
5. Reconnect air supply.
FIG. 8
Too Deep
Turn the adjustment knob counter clockwise
FIG. 9
Too Shallow
Turn the adjustment knob clockwise
ADJUSTING THE EXHAUST
The direction of the exhaust vent can be changed by turning
the top cover (FIG 10).
FIG. 10

FIRING LOCK

The tool is equipped with a firing lock button beside the
trigger. Make sure it is in the position of the Lock Symbol
when tool is not in the use. Before using the tool, turn the
FIRING LOCK to the position of the Unlock Symbol.

MAINTENANCE

JAM CLEARING

Occasionally, a nailer may become jammed in the firing
mechanism of the tool, making the tool inoperable. To
remove a jammed nailer, follow the steps below:
Flush
1. Disconnect air hose.
2. Open the feeder cover and magazine cover.
3. Remove nails from the tool.
4. Remove jammed nail, using pliers or a screwdriver if
required.
5. Reconnect the tool to the air resource.
6. Reload the tool with nails.
7. Close the magazine cover. Close the feeder cover
securely.

CLEANING

Flush
WARNING
When cleaning a tool be careful not to disassembly any
portion of the tool since internal components may be
misplaced or safety components may be improperly
mounted. Certain cleaning agents such as gasoline, carbon
tetrachloride, ammonia. etc. may damage plastic parts and
o-rings.
WARNING
Do not attempt to clean by inserting pointed objects
through openings. Sharp edges may damage internal
components causing a serious hazard.
Ventilation openings, the work contact element, and the
trigger must be kept clean and free of foreign matter.
7 - ENG LISH