Nail Loading; Removing The Nails; Methods Of Operation; Cold Weather Operation - Powermate VX CRN175P Manuel De L'opérateur

NAIL LOADING

WARNING
When loading the tool's magazine, check that the nail tips
contact the wear rail and slide smoothly against the surface
of the magazine. If the nails are not loaded properly, the tool
will misfire and nails can be deflected, causing the tool to
react in an unexpected manner, and damage the tool.
1. Connect air supply.
2. Depress the feeder cover latch and open the cover
(FIG.6).
3. Open the magazine cover (FIG 7).
4. Slide the coil of nails onto the spool with the nails
pointing down (FIG 5).
5. Insert the first nail into the feeder (FIG 7). The first nail
should sit in the nose of the tool.
6. Position the second nail between the guides (FIG 7), the
nail heads should lie in the track.
7. Close the magazine cover (FIG 7).
8. Securely close the feeder cover (FIG 6), snapping it into
place. Be sure that the feeder cover is locked before
resuming operation.
FIG. 6
FIG. 7
Feeder
Guide
Latch
Magazine
Nailer
6- ENG LISH
WARNING
KEEP THE TOOL POINTED AWAY FROM YOURSELF AND
OTHERS WHEN LOADING FASTENERS. FAILURE TO DO SO
COULD RESULT IN POSSIBLE SERIOUS PERSONAL INJURY.
NEVER LOAD FASTENERS WITH THE WORKPIECE CONTACT
OR TRIGGER ACTIVATED. DOING SO COULD RESULT IN
POSSIBLE SERIOUS PERSONAL INJURY.

REMOVING THE NAILS

1. Disconnect air supply.
2. Open the feeder cover and magazine cover (FIG 6).
3. Lift the nails strip from the spool and remove the
remaining coil nails.

METHODS OF OPERATION

This tool is equipped with the safety and does not operate
unless the safety is depressed.
The methods of operation to drive nails with this tool is
contact actuation mechanism.
WARNING
To avoid double firing or accidental firing due to recoil.
• Do not press the tool against the wood with excessive
force.
• Separate the tool from the wood as it recoils after nailing.
1. Pull the trigger with the tool off the workpiece.
2. Depress the safety against the workpiece to drive a nail
3. Move the tool along the workpiece witha bouncing
motion. Each depression of the safety will drive a nail. As
soon as the desired number of nails have been driven,
remove finger from the trigger.
NOTE:
• Always handle nails and package carefully. If nails are
dropped, collating bent may be broken, which will cause
mis-feeding and jamming.
• After nailing:
1. Disconnect air hose from the tool.
2. Remove all nails from the tool.
3. Supply 5-10 drops of pneumatic tool lubricant into
the air plug on the tool.
4. Open the petcock on the air compressor tank to drain
any moisture

COLD WEATHER OPERATION

WARNING
DO NOT USE A FROZEN TOOL. Allow tool to thaw before
using. Moisture frozen in the tool may impede internal
components resulting in the risk of injury and/or tool
damage.