SSS Siedle Kit Smart Gateway Vario Information Produit page 10

Programming
1 Activate the programming mode
on the SNG 850-... Briefly press the
programming mode button, LED 1
flashes every 2 seconds.
Link
In-Home
Status
Reset
Prog.
4 Sek.
3 Press the programming button for
4 seconds. The In-Home LED then
flashes in a one-second rhythm. The
Smart Gateway is now in the pro-
gramming mode.
10
2a At the door station, hold down
the light/programming button for
4 seconds. A protracted acknowl-
edgement tone is then audible
which is repeated every 5 seconds
as long as the programming mode
remains active.
4 On the door station, press and
hold the desired call button for
4 seconds until a sustained tone can
be heard from the door loudspeaker.
The call button is now assigned to
the bus indoor device.
2b On the door station, press and
hold the programming button
behind the front panel for 4 sec-
onds. A sustained acknowledge-
ment tone will sound, which briefly
repeats every 5 seconds while pro-
gramming mode is active.
4 Sek.
5 End the programming process by
pressing the programming mode
button on the set line rectifier. The
call button is now assigned to the
Smart Gateway.