Areas Of Application; Safety; Marking Of Information In The Instruction For Use; Personnel Qualifications - Zehnder Pumpen SWH 100 Manuel D'utilisation

1.4 Areas of application

The SWH waste water sets are suitable to handle waste water from hand basins, sinks, washing machines etc. can be used for domestic,
industrial and agricultural purposes. Ideal where waste water arises below waist drain level.
The S-SWH lifting unit is suitable for pumping slightly acid condensate, aggressive or saline media (max. 15 % salt content), for use behind
water softeners and for condensate produced.
Attention The SWH range is not suitable for sewage water from toilets and fatty water from kitchens. The sewage lifting units of the
series SWH may not promoting wastewater and greasy wastewater or effluent which contain ingredients attack the materials of the
pump or sump can be used.

2. Safety

(from: "VDMA-Standard publication 24 292")
These instructions for use contain general information, which should be noted when setting up, using and servicing the equipment. Installers
and / or users must read and understand in detail these instructions prior to installation and servicing. These instructions must always be
available at the site of the installation. All safety instructions must be full observed.

2.1 Marking of information in the instruction for use

Danger symbol in accordance with DIN 4844 - W9,
for warnings regarding electrical current the following symbol is used
Danger symbol in accordance with DIN 4844 - W8
The word "Attention" or "Caution" is used to introduce safety instructions whose non-observance may lead to damage to the machine and
its functions.
2.2 Personal qualification
All personnel involved in the operation, maintenance, inspection and installation of the machine must be fully qualified to carry out the work
involved. Personnel responsibilities, competence and supervision must be clearly defined by the operator. If the personnel in question are not
already in possession of the requisite know- how, appropriate training and instruction must be provided. If required, the operator may
commission the manufacturer/supplier to take care of such training. In addition, the operator is responsible for ensuring that the contents of
the operating instructions are fully understood by the responsible personnel.
2.3 Dangers arising due to non-compliance with safety advice
Ignoring of safety instructions can lead to danger of personnel and to the environment as well as causing possible damage to the equipment.
Non-compliance with safety instructions can lead to the loss of right to claim damages. Non-compliance with safety instructions can lead for
example to:
- Breakdown in important functions of the equipment
- Breakdown in prescript methods for maintenance and upkeep
- Danger of injury from electrical, mechanical or chemical sources
- Environmental damage resulting from leaks of environmentally dangerous substances
2.4 Safety conscious work
These safety instructions, as well as all national safety requirements and extra internal company precautions or such laid down by the owner
of the equipment must be observed.
2.5 Safety information for the owner / operator
- Any parts of the machine which could be a possible source of hot or cold burns should be covered.
- Covering for rotating parts (i.e. coupling) should be not removed while the machine is in use.
- Leak out (i.e. sealing of shaft) of dangerous substances (i.e. explosives, poisons, hot liquids) have to be handled in such a way that no
danger to persons or the environment may occur. Legal requirements must be observed.
- Danger resulting from electrical current must be prevented. (For more information consult your local electricity board.)
12
GB
B