Adjustment Instructions; Adjusting The Handlebar - Sunny Health & Fitness ROW-N-RIDE P2100 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ADJUSTMENT INSTRUCTIONS

7
10
31
18
21
31
25
29
32
28
31
42
28
31
42
28
37
37
37

ADJUSTING THE HANDLEBAR

Loosen the Knob (No. 10) and pull. Raise or lower the Handlebar Tube (No.
7) to desired height. Tighten the Knob (No. 10).
ADJUSTING THE SEAT
Loosen and remove the Knob (No. 21) located under the Seat Connecting
Tube (No. 31). Move the Seat (No. 18) to desired position, then re-tighten
the Knob (No. 21).
ADJUSTING THE SEAT TUBE
To adjust the Seat Tube (No. 25), lift the Seat Connecting Tube (No. 31).
Remove the Pin (No. 29) from Front Connecting Tube (No. 32) and raise
or lower the Seat Tube (No. 25) to desired position. Re-insert the Pin (No.
29) to secure. Then lower the Seat Connecting Tube (No. 31). Raising or
lowering Seat Tube (No. 25) will change the difficulty of your exercise.
NOTE: Make sure Exercise Bands (No. 42) are not hooked to Main Frame
(No. 28) when adjusting the Seat Tube (No. 25). Do not extend the Seat
Tube (No. 25) to pass "MAX" line.
ADJUSTING THE EXERCISE BAND
You can adjust the difficulty of your exercise by adjusting the Exercise
Bands (No. 42). To reduce difficulty, unhook Exercise Bands (No. 42) from
the Main Frame (No. 28) and connect the Exercise Bands (No. 42) to the
hooks on the Seat Connecting Tube (No. 31).
ADJUSTING THE BALANCE
In order to achieve a smooth and comfortable ride, you must ensure that the
bike is stabled and secured. If you notice that the bike is unbalanced during
use, you should adjust the End Caps (No. 37) located on the rear stabilizer
until the bike becomes levelled with the floor surface.
13

Publicité

Table des Matières
loading

Table des Matières