KPS DMM4500PV Manuel D'utilisation page 25

When using test leads or probes, keep your fingers behind the finger guards.
Use caution with voltages above 30 Vac rms, 42 Vac peak, or 60 Vdc. These voltages
pose a shock hazard.
If the test lead is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
To reduce the risk of fire or electric shock, do not use this product around explosive
gas or in damp locations.
DO NOT USE the test leads when the internal white insulation layer is exposed.
DO NOT USE the test leads above maximum ratings of CAT. environment, voltage and
current, that are indicated on the probe and the probe tip guard cap.
DO NOT USE the test leads without the probe tip guard cap in CAT III and CAT IV
environments.
DO NOT USE the test leads to measure over 1000V that is connected to MAINS
directly.
Maintenance
Do not attempt to repair this test lead set. It contains no user-serviceable parts. Repair
or servicing should only be performed by qualified personnel.
Cleaning
Clean the test lead with a water and mild detergent. DO NOT use abrasives or
solvents and DO NOT IMMERSE in liquid.
Specification
Input Impedance:
Overvoltage Category: CAT 0 1500V AC, 2000V DC
Pollution Degree 2
Exposed probe tip length : 19 mm to 4 mm (0.75 inch to 0.16 inch)
Environmental ratings : -10°C to 45°C (-4°F to 113°F), 80% R.H.
Altitude : 2000 m (6,562 ft)
Safety Standard : EN61010-031
CAT
Circuits that are not directly connected to Mains
0
The circuits directly connected to Low-voltage installation.
Ⅱ
The building installation.
Ⅲ
Ⅳ The source of the Low-voltage installation.
Symbols as marked on the test lead and Instruction card
Risk of electric shock
DC measurement
Earth ground
Conforms to EU directives
! CAUTION
CAT II 1000V AC, 1500V DC
CAT III 1000V, CAT IV 600V.
Application field
See instruction Card
!
~
AC measurement
~ —
Both direct and alternating current
Equipment protected by double
or reinforced insulation
24
EN