MSI MPG B650I EDGE WIFI Manuel D'utilisation page 40

JOCFS1: Safe Boot Jumper
This jumper is used for Safe Boot. Once enabled, the system will boot with default
settings and lower PCIe (from CPU) mode.
BAT1: CMOS Battery
If the CMOS battery is out of charge, the time in the BIOS will be reset and the data of
system configuration will be lost. In this case, you need to replace the CMOS battery.
WARNING
KEEP OUT OF REACH OF CHILDREN
Swallowing can lead to chemical burns, perforation of soft tissue, can death.
∙
Severe burns can occur within 2 hours of ingestion.
∙
If you think batteries might have been swallowed or placed inside any part of
∙
the body, seek immediate medical attention.
Normal
(default)
Boot with the saved
BIOS settings.
Replacing CMOS battery
1. Unplug the battery wire from the BAT1 connector and
remove the battery.
2. Connect the new CR2032 battery with wire to the
BAT1 connector.
38
Enabled
Apply the BIOS default
settings and lower PCIe
(from CPU) mode for
Safe Boot.