ELCA Genio Manuel D'utilisation page 11

Multi_ING_Man_GenioPUNTOE_03
2.5 CONNECTION OF THE COMMONS IN THE RECEIVING UNIT
The wiring of the commons (C) in the terminals of the AR GENIO-A.E and AR GENIO-D.E receiving unit main board
is made easier and safer by the use of a common connection comb.
The following rules should be followed when using the comb:
1. Correctly thread the comb close to the terminal board and in correspondence with the commons that are to be
connected together. Tighten the screws of each comb tooth well.
2. If connecting with different commons, use cutting nippers to cut the common to be isolated. Be careful that the
stump remaining on the comb does not cause short circuits and make sure that the removed tooth does not fall
inside the electronic cards.
3. When using receiving units supplied at 12Vdc and 24Vdc, eliminate the first tooth (of the 3 teeth which are
visibly closer to each other) and create a wire connection between the "Com. Funz." Terminal and the terminal
where one of the comb teeth enter.
Note: Crimped cable jumpers can be found in all the other receiving units.
2.6 INFORMATION NECESSARY FOR KEEPING THE RADIO REMOTE
CONTROL SYSTEM FULLY EFFICIENT
Please remember that during maintenance operations the receiving unit must not be powered and the
transmitting unit must be switched off.
Even though the Radio Remote Control system does not need particular maintenance, certain steps are necessary
to ensure that it remains efficient.
It is suggested that periodically the following be done:
- Transmitting unit:
Clean with a brush and a damp cloth. Do not use alcohol and/or solvents.
•
Make sure that the battery and battery holder contacts are clean.
•
Check box integrity.
•
Check lid gasket integrity, as well as the bellows and the lever switch or pushbutton caps. Replace if cuts
•
(which can also be caused by normal wear) are present.
- Receiving unit:
Check the integrity of the cover gasket and make sure it is water and dust proof.
•
In addition to the recommendations given above, it is a good idea to follow the points below in order to keep the
Radio Remote Control System efficient.
- Transmitting unit:
Try to protect the unit from jets of water and heavy rain.
•
Do not leave the unit exposed to sunlight for no reason.
•
Do not use jets of water or pressurised air to clean the unit.
•
Do not immerse the device into water.
•
- Receiving unit:
Make sure that the box is properly closed again after opening.
•
Common connection comb.
- Page 7 -
GENIO-PUNTO.E Radio remote control system