Thermador VTN1DZ Instructions D'installation page 5

Installing the integral blower
NOTE: Blower and hood image views will vary depending
on model.
1. Thread one (x1) 4m flange nut (included with the
hood) half-way down each of the two weld studs
indicated.
2. Slide the blower mounting plate behind the nuts on
the weld studs.
3. Install two (x2) 4m flange nuts (included with hood) to
the top weld studs and tighten.
4. Tighten the two (x2) nuts from step 1 to fully secure
the blower to the hood.
5. Connect the blower's plug connector to the connector
present inside the hood.
4