Personal Safety - PRO-POINT 8535148 Manuel D'utilisateur

V 3.06

PERSONAL SAFETY

CAUTION! Wear protective equipment approved by the Canadian
Standards Association (CSA) or American National Standards
Institute (ANSI) when using the tool.
1. Dress properly, wear protective equipment. Use breathing,
ear, eye, face, foot, hand and head protection. Always wear
ANSI approved impact safety goggles, which must provide
both frontal and side protection. Protect your hands with
suitable gloves. Protect your head from falling objects by
wearing a hard hat. Wear an ANSI approved dust mask or
respirator when working around metal, wood and chemical
dusts and mists. Wear ANSI approved earplugs. Protective,
electrically non-conductive clothes and non-skid footwear
are recommended when working. Wear steel-toed boots to
prevent injury from falling objects.
2. Someone should be within range of your voice or close
enough to come to your aid when you work near a lead
acid battery.
3. Have plenty of fresh water and soap nearby in case battery
acid contacts the skin, clothing, or eyes.
4. Wear complete eye protection and clothing protection. Avoid
touching eyes while working near batteries.
5. If battery acid contacts skin or clothing, wash immediately
with soap and water. If acid enters they eyes, immediately
flush with running cold water for at least ten minutes and
seek medical attention immediately.
6. Never smoke or allow a spark or flame in the vicinity of a
battery or engine.
7. Remove personal metal items such as rings, bracelets,
necklaces, and watches when working with a lead acid
battery. A lead acid battery can produce a short circuit
current high enough to weld a ring or the like to metal,
causing a severe burn.
8. Use the charger for charging regular, AGM, gel cell, deep
cycle (12V) batteries. It is not intended to supply to a low
voltage electrical system. Do not use the battery charger
4
6/12/24V Battery Charger
For technical questions call 1-800-665-8685
8535148