Main Components - inshape CT50 Manuel D'instructions

step 5
Connect the pulse cables (50) and the sensor
cable (18) to the sockets on the computer (9).
Insert two 1.5 V AAA batteries into the
battery compartment on the computer (9).
Check that the batteries are correctly fitted.
Screw the computer (9) securely to the
computer bracket on the handlebar post (2)
using screws (55) and washers (54).
Tighten all the screws.
The equipment is now assembled and ready
for use.

Main components

a. Handlebars
b. Stationary handlebar
c. Pulse sensor
d. Computer
e. Tension knob
f. Front stabiliser
g. Base
h. Rear stabiliser
a
b
c
d
e
h
g
f
29
GB