Publicité
STEP 1
Use a pencil to trace around the
bottom two corners of the drawer
onto the back of the drawer front.
Remove the existing drawer front
and set aside. Remove existing
drawer box and slides from cabinet
and discard if desired.
#2
#2
STEP 2
Install the right and left Blum
release triggers on the bottom of
the drawer using (4) #6 x 1/2" pan
head screws (See Figure A).
STEP 3
Install the figure 8 brackets onto
the front of the drawer using the
screws that come inside the same
bag as the figure 8 brackets (See
Figure B-1).
Once the figure 8 brackets have
been secured to the drawer box,
attach the drawer front.
Drill a 7/64" wide X 3/8" deep pilot
hole through the middle of each
bracket and into the back of the
drawer front. Be careful to not drill
through the drawer front. Secure
the drawer box to the drawer front
using the figure 8 brackets and
screws provided in the pack (See
Fig. B-3).
2
FIG. A
FIG. B-1
Customer Service: 800-626-1126 | rev-a-shelf.com
Single and double drawer units both shown
FIG. B-2
Publicité
