Fitting The Cuff; Taking Blood Pressure Readings - ProMed MTX Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
400110_MTX_promed_West_NEUSS.qxd:Blutdruckmessgerät
GB
3 Getting Started / 4 Operation
3.7 Switching beeps on/off
Beeps sound when you take a measurement using the MTX blood pressure meter. You
can switch off the beeps by making the following setting.
1. To switch between "beep on" and "beep off", press and hold the TIMER button
until
2. Press the TIMER button
"
".
3. Press the MEMO button to switch between "
4. Confirm your selection by pressing the START button (or press the TIMER
button
to make the next setting: " Switch radio clock on/off ", see section 3,
subsection 3.3).
If you select "
measurements.
4 Operation

4.1 Fitting the cuff

First attach the free end of the cuff's air tube to the designated connector
unit. Open up the preformed cuff to a ring and slip it over the bare left upper arm just
above the elbow region. If wearing tight clothing, ensure that the circulation in the
arm is not impaired when rolling up the sleeve.
The tube should run along the centre of the inner arm towards the palm of the hand.
Ensure that the cuff itself is not twisted in any way. Fasten the pressure cuff in such a
way that it fits tightly but does not constrict the arm.
• Take readings while in a seated position.
• Relax your arm and rest it lightly on a surface such as a table. Relax during the
measuring process: do not move or talk, as this can affect the results.

4.2 Taking blood pressure readings

Single reading
To take a single measurement, you have to switch on the device using the ON/OFF
switch
and be in standby mode. You first have to complete any settings you re-
quire as per section 3, subsections 3.3, 3.5, 3.6 and 3.7.
1. Press the START button. The device carries out a self test. Once this is complete,
"
" appears on the display. 5 short beeps sound during the procedure.
32
All manuals and user guides at all-guides.com
and "
" appear flashing in the display.
again. "
", the beep function remains switched off when you take
25.08.2010
" appears in the display, followed by
" and "
".
10:15 Uhr
Seite 32
on the

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

400110

Table des Matières