Getting Started - ProMed MTX Mode D'emploi

400110_MTX_promed_West_NEUSS.qxd:Blutdruckmessgerät
GB

3 Getting Started

Note that you have to reset the date and time each time you replace the batteries, unless
this is set automatically via the radio clock when the device is switched on using the
ON/OFF switch
WARNING
BATTERY SAFETY INFORMATION
• Do not disassemble batteries!
• Clean the battery and device contacts if necessary before putting in the
batteries!
• Remove discharged batteries from the device immediately!
• Increased risk of leakage, avoid contact with skin, eyes and mucous
membranes! If battery acid comes in contact with any of this parts,
rinse the affected area with copious amounts of fresh water and seek
medical attention immediately!
• If a battery has been swallowed seek medical attention immediately!
• Replace all of the batteries simultaneously!
• Only replace with batteries of the same type, never use different types
of batteries together or used batteries with new ones!
• Insert the batteries correctly, observing the polarity!
• Keep the battery compartment well sealed!
• Remove the batteries from the device if it is not going to be used for
an extended period!
• Keep batteries out of children's reach!
• Do not attempt to recharge these batteries! There is a danger of
explosion!
• Do not short circuit! There is a danger of explosion!
• Do not throw into a fire! There is a danger of explosion!
• Keep unused batteries in their packaging away from metal objects in
order to prevent short circuiting!
• Do not throw used batteries into the household refuse; put them in a
hazardous waste container or take them to a battery collection point,
at the shop where they wereb purchased!
3.2 Using a mains adaptor
Alternatively, you can also run the device using a special power supply unit
(MEDISANA item no. 51036 not supplied). Connect it to
vice. In this case the batteries remain in the unit.
Inserting the connector into the back of the blood pressure monitor switches the bat-
teries off mechanically. It is necessary, therefore, to plug the mains adaptor into the
mains socket first of all and then to connect it to the blood pressure monitor. If the
28
All manuals and user guides at all-guides.com
. The previous measuring results are saved.
25.08.2010 10:15 Uhr
on the back of the de-
Seite 28